耐磨离心卧式泥浆泵雷竞技官网最新版

1.泵的正常保护雷竞技官网最新版

　1) The suction piping system of the pump is not allowed to have the appearance of air leakage. The grid of the inlet pump pool should meet the requirements of the particles that the pump can pass, so as to prevent large particles or long fiber materials from entering the pump and causing blockage.

　2) It is necessary to replace the easily damaged parts in time, the maintenance device should be accurate, the gap adjustment should be reasonable, and there should be no signs of tight friction.

　3) The water pressure and water volume of the bearing should be satisfied with the rules, and the tightness of the packing should be adjusted (or replaced) at any time to avoid the formation of shaft seal leakage. 　 And replace the bushing in time.

　4) When replacing the bearing, make sure that there is no dust in the bearing assembly and the lubricating oil is clean. When the pump is running, the bearing temperature should generally not exceed 　60-650C, and the highest should not exceed 750C.

　5) To ensure the coaxiality of the motor and the pump, ensure that the elastic pad in the coupling is intact and accurate, and replace it in time if it is damaged.

　6) Ensure that the pump components and piping system are accurate, strong and reliable.

2.泵的拆卸和装配雷竞技官网最新版

　1) The disassembly and assembly of some pump heads. The disassembly and assembly of some pump heads and gap adjustment should be carried out according to the assembly drawing. The impeller, sheath, rear guard plate, and sealing box are all equipped with lifting tools for disassembly and assembly (the lifting tools need to be ordered separately). For the disassembly and assembly method, please refer to the "Instruction Manual for Hoisting Tools".

2)轴封部件的填料轴填料的拆卸和装配应按装配图进行。为保证填料轴封的密封效果，应尽量按图中所示切割填料开口形状。填料的开口应错开108度。