High Pressure Water Pump Multistage Horizontal Centrifugal Pump

Our personnel are always in the spirit of 'continuous improvement and excellence', and with the superior quality products, favorable price and good after-sales services, we try to win every customer's trust forCeramic Sand Slurry Pump,年代ewage Suction Pump,Dirty Water Sump Pump. We always follow the management principles of science first, quality first, and customer first, with the goal of promoting product structure optimization and production standardization. In today's era, the ability and performance of knowledge workers are the source of a company's core competitive advantage, therefore, the acquisition, retention and development of knowledge workers has become a key factor in corporate development. The company adheres to the business philosophy of 'cooperation is the first time, service is eternal'.

Mechanical Seal Electric Multistage Water Pump is mainly used for industrial and urban water supply and drainage, high-rise building pressurized water supply, garden sprinkler irrigation, fire pressurization, long-distance water supply, heating, bathroom and other cold and warm water circulation pressurization and equipment supporting.

Mechanical Seal Electric Multistage Water Pump Installation:

1. Preparations before installation.

1) Check the water pump and motor.

2)准备工具和起重设备。

3) Check the foundation of the machine.

2. Installation sequence:

1) The whole set of water pump is transported to the site, and the motor is installed if the base is attached. It is not necessary to remove the pump and motor when leveling the base.

2) Put the base on the foundation, put a wedge-shaped horn near the anchor bolts, and set the base up to about 20-40 mm high, and prepare to fill it with water screw slurry after leveling.

3) Check the levelness of the base with a spirit level. After leveling, tighten the anchor nut and fill the base with cement slurry.

4) After the cement has dried for 3-4 days, check the levelness.

5) Wash the dirt on the support plane of the base, the feet of the water pump and the feet of the motor, and put the water pump and the motor on the base.

6) Adjust the level of the pump shaft, tighten the nut properly after leveling, to prevent it from moving, install the motor after the adjustment is completed, and place an iron plate where it is not level.

There is a certain gap between the pump and the coupling.

7) Put a flat ruler on the coupling and check whether the axis line of the water pump and the axis of the motor coincide with each other. If it is not heavy, put a sheet under the feet of the motor or pump to make the outer circle of the two couplings and The flat ruler is even, and then take out several thin iron pieces of the pad, replace the iron pieces with the whole iron plate that has been planed, and recheck the installation.

In order to check the accuracy of the installation, use a feeler gauge at several opposite positions to measure the gap between the two coupling planes. The difference between the large and small gaps on the coupling plane should not exceed 0.3 mm, and the difference between the center lines of the two ends or left and right The number must not exceed 0.1 mm.

To promote the development of the company, our primary task is to ensure the quality of our High Pressure Water Pump Multistage Horizontal Centrifugal Pump so as to gain the trust of our customers. The improvement of our company's comprehensive strength provides necessary conditions for the development and trial production of new products. Our company always implements a rigorous quality control system, with a sound sales network and service system.