Horizontal Self-Balanced Bb5 Multistage Centrifugal Pump, Duplex Stainless Steel Multi-Stage Sea Water Pump

Wining the majority of the crucial certifications of its market forHorizontal Split Case Pump,Submersible Sewage Pump With Cutter,Big Solids Gravel Sand Pump. We firmly believe that through our unremitting efforts and team cooperation, our company's future will be certainly be better! We will satisfy you with our professional service! All the products sold by our company are subject to strict quality inspection, and the price is low. We always give back to consumers with advanced technology and excellent quality.

IH type stainless steel chemical centrifugal pump installation

First. Whether the installation of the IH stainless steel chemical centrifugal pump is reasonable has a very important impact on the normal operation and service life of the pump. Therefore, it must be carefully corrected before installation, and must not be sloppy, the shape and installation size of the pump.

Second, it must be ensured that the pump does not exceed its allowable cavitation allowance during operation. The suction height (or backfill height) of the pump must be determined according to the characteristics of the cavitation surplus of the pump, the resistance loss characteristics of the pipeline and the suction liquid surface pressure of high temperature water.

1. When the pump is used, the bottom valve should be installed on the suction pipeline, and the soil liquid screw hole or valve should be installed on the outlet pipeline for the purpose of priming the pump before starting.

2. When the pump is used for backfilling, valves and filters should be installed on the suction line to prevent debris from entering.

Three. The suction and discharge pipes should have additional brackets and cannot be used as supports.

Four. The installation site should be convenient for touring inspection and maintenance.

Five. Installation order of IH stainless steel chemical centrifugal pump:

1. Place the unit on the foundation buried with anchor bolts, and place a pair of wedge pads between the base and the foundation for alignment purposes.

2. Loosen the coupling. Use a spirit level to place it on the pump shaft or the base respectively. After adjusting the leveling pads to correct the level of the unit, tighten the anchor bolts properly to prevent walking.

3. Pouring the base and the ground screw inspection hole with concrete.

4.房颤ter the concrete dries up, tighten the anchor bolts and recheck the ice level of the pump shaft.

5. After connecting the pipeline and determining the rotation direction of the prime mover, connect the coupling, and then check the concentricity of the shaft again, measure the outer circle of the coupling, the difference between the left and right should not exceed 0.1mm, the two couplings The end face gap, the difference between the large and small imi within a week shall not exceed 0.3mm.

6. After 3-4 hours of actual operation of the unit, make a post-inspection. If there is no bad phenomenon, the installation is considered qualified.

To be a result of ours specialty and repair consciousness, our corporation has won a good popularity amid consumers everywhere in the environment for Horizontal Self-Balanced Bb5 Multistage Centrifugal Pump, Duplex Stainless Steel Multi-Stage Sea Water Pump. The standard of high starting point, high grade and high efficiency, and our core concept of faster, stronger and more perfect inspire every great wheel employee to forge ahead. We will follow the development of Chinese society and technology and respond to market changes through technological innovation.