Mechanical Seal Electric Multistage Water Pump is mainly used for industrial and urban water supply and drainage, high-rise building pressurized water supply, garden sprinkler irrigation, fire pressurization, long-distance water supply, heating, bathroom and other cold and warm water circulation...
We are an energetic company with wide market forMultistage High Pressure Pump,Electric Mine Dewatering Multistage Pump,Submerged Sump Pump. The continuous expansion of the overall industry sector has brought us market opportunities and challenges, and created a lot of space for enterprises to enhance our value at the same time. We've our personal manufacturing unit and sourcing business. Expertise and know-how ensure that we are always enjoying the trust from our customers in our business activities.
Mechanical Seal Electric Multistage Water Pump is mainly used for industrial and urban water supply and drainage, high-rise building pressurized water supply, garden sprinkler irrigation, fire pressurization, long-distance water supply, heating, bathroom and other cold and warm water circulation pressurization and equipment supporting.
Mechanical Seal Electric Multistage Water Pump Installation:
1. Preparations before installation.
1) Check the water pump and motor.
2) Prepare tools and lifting equipment.
3) Check the foundation of the machine.
2. Installation sequence:
1) The whole set of water pump is transported to the site, and the motor is installed if the base is attached. It is not necessary to remove the pump and motor when leveling the base.
2)把基地基础,wedge-shaped horn near the anchor bolts, and set the base up to about 20-40 mm high, and prepare to fill it with water screw slurry after leveling.
3) Check the levelness of the base with a spirit level. After leveling, tighten the anchor nut and fill the base with cement slurry.
4) After the cement has dried for 3-4 days, check the levelness.
5) Wash the dirt on the support plane of the base, the feet of the water pump and the feet of the motor, and put the water pump and the motor on the base.
6) Adjust the level of the pump shaft, tighten the nut properly after leveling, to prevent it from moving, install the motor after the adjustment is completed, and place an iron plate where it is not level.
There is a certain gap between the pump and the coupling.
7) Put a flat ruler on the coupling and check whether the axis line of the water pump and the axis of the motor coincide with each other. If it is not heavy, put a sheet under the feet of the motor or pump to make the outer circle of the two couplings and The flat ruler is even, and then take out several thin iron pieces of the pad, replace the iron pieces with the whole iron plate that has been planed, and recheck the installation.
In order to check the accuracy of the installation, use a feeler gauge at several opposite positions to measure the gap between the two coupling planes. The difference between the large and small gaps on the coupling plane should not exceed 0.3 mm, and the difference between the center lines of the two ends or left and right The number must not exceed 0.1 mm.
Our company since its inception, always regards product quality as enterprise life, continuously improve production technology, improve product quality and continuously strengthen enterprise total quality management, in strict accordance with the national standard ISO 9001:2000 for Ihg One-Stage One-Suction Corrosive Medium Chemical Centrifugal Pump. We welcome friends from all over the world to visit and guide us so that we can achieve the win-win goal together. Uphold the integrity of management, customer demand-driven, we are committed to providing our customers with high-quality competitiveness of goods and services.
QR Code
