Yw Submerged Sewage Pump

We have always insisted the quality strategy,' Not the largest, but the best', and try our best to build a modern enterprise with 'unique and quality'潜水器水泵湖雷竞技app下载网址雷竞技官网最新版,Wearable Centrifugal Mine Water Pump,The Submersible Pump. We take quality as life and reputation as capital. After long-term practice and continuous improvement, the processing quality is constantly improved. The processed products are of high quality and low price and the delivery is on time. We look at the world-class enterprises and strive to shorten the gap with them.

Submerged Motor Pump

SP type submerged motor slurry pump, which is immersed in the liquid and used to transport corrosive, coarse particles and high concentration slurry.

Maintenance

The structure is sturdy. When the assembly and installation are correct, the life is long, and the maintenance is less.

(a), impeller adjustment (installation)

There are no specific regulations for the adjustment of the impeller.

When the impeller and casing are worn to such an extent that the performance and efficiency of the pump are severely changed, any worn parts need to be replaced.

(b), bearing lubrication

Properly assembled and oiled before assembly (see bearing assembly). It can prevent water or other foreign substances from entering the bearing, which can extend the service life of the bearing.

The maintenance personnel must make a good judgment to open the bearing body every certain time (not more than 12 months), check the bearings and lubricants, and then, determine how long the next maintenance will take.

If you think it is necessary, you should add lubricating oil regularly. You can use the lubricating oil nozzle provided on the bearing body. Regular small amount of lubricating oil is superior to a large amount of lubricating oil every other time. Do not add too much oil to the bearing. It is also recommended to use clean lubricants.

(c) Replacement of worn parts

The wear rate of the liquid delivery pump is related to the working conditions and the abrasiveness of themedium. Therefore, the life of wear parts such as impeller, body, etc. varies depending and installation conditions.

When the operation no longer meets the specific performance requirements, the wear parts must be replaced.

If the pump is used for a specific working condition for the first time, especially if the wear parts are damaged, it will have serious consequences. It is recommended that after the product is started, check the parts at regular intervals and estimate their degree of wear to determine the life of the parts .

SP SPR使用和features

SP and SPR pumps are vertical centrifugal, which are immersed in liquid and used to transport abrasive, coarse particles and high concentration slurry. There is no need for any shaft seal and shaft seal water, and it can work normally under the condition of insufficient suction.

The body is made of wear-resistant metal, and the impeller is made of wear-resistant metal, rubber or polyurethane.

The parts under the SPR type immersion liquid are lined with rubber, which is suitable for conveying corrosive slurry.

The submersible pumps with the "L" letter in the model number as the extended shaft series can be applied to industrial and mines with deeper liquid levels. This pump adds a guide bearing structure on the basis, which runs more smoothly and is more widely used. However, flush water needs to be attached to the guide bearing.

Our company adheres to the core values of quality first and service winning, and is willing to work closely with colleagues and customers all over the world to promote the development of the Yw Submerged Sewage Pump industry. Over the past few years, tens of thousands of new and old customers have established cooperative relations with our company, and they have given a very high evaluation of our products and after-sales services. We strengthen the alliance, collaboration, reinvestment and joint development overseas.